Swamp coolers work ok until it reaches 94 degrees.
Roof swamp cooler not blowing cold air.
Every 1000 feet of air supplied requires 2 square feet of exhaust openings.
Typical on off controls for evaporative cooler.
When your swamp cooler is not blowing enough cold air the first thing you may want to check is the water system.
But if you feel like your cooler is blowing hotter air than normal it may be worth getting an evaluation.
If your swamp cooler pads are not getting wet you are going to have warm air blowing from your cooler.
If you do not have exhaust ducts you must have your windows or doors open to allow for proper airflow.
They are also available in wall or window mounted.
Cool air sinks after all.
Turn on the internal water pump for ten minutes to completely saturate the cooling pads before turning on the fan.
Let s start with the easy things first.
If this doesn t resolve the issue it may be time to replace the pump.
But there may be issues with placement leakage or supply that prevent that.
Make sure you have enough water supplied to your swamp cooler verify that the water pump is operating properly and make sure the distributor is not clogged.
If only the fan vent is on then you are just blowing the outside air into your house.
We re right in the middle of summer and these summer rains can interfere with swamp coolers effectiveness.
Consider portable evaporative coolers.
However the more humid the air in your house is the less effective your evaporative cooler will be.
To solve this problem keep a few windows cracked to let dry air in and damp air out.
Make sure you have water in the bottom of your swamp cooler.
As you run a swamp cooler it makes moist air in your home as water evaporates into the air.
So by increasing the amount of water going to the pads by 50 the unit cools the house down faster and the pads don t dry out.
If your swamp cooler is not blowing hard enough or hardly blowing air at all the swamp cooler pump may not be working properly.
The problem is obvious.
Swamp cooler not blowing air.
Inside your cooler the pump is pumping water to your pads and the blower is pushing cold air into your home.
The water is not getting to the pads.
Also make sure to move the cooler close to an open window for optimal airflow.
If there is not enough air coming from the unit make sure there is enough exhaust for the cooler.
So it is time to investigate why not.
Swamp coolers are most efficient on the roof.
Turn off the unit and clean the pump.
At that point they stop cooling as well because the pump can not get enough water on the pads to keep them wet.
If it is 95 degrees out that is what you are going to have inside your home.